Starter/generator employing resonant-converter-fed induction machine - Part II: Hardware prototype

Küçük Resim Yok

Tarih

2000

Dergi Başlığı

Dergi ISSN

Cilt Başlığı

Yayıncı

Ieee-Inst Electrical Electronics Engineers Inc

Erişim Hakkı

info:eu-repo/semantics/closedAccess

Özet

Feasibility of operation of a new procedure to start a jet engine (JE) and to generate power by means of a single induction machine (IM) directly coupled to the turbine has been shown by means of a hardware prototype. An introduction, background, operation principle of this type of a system and software simulation portion was presented in Part I of this article. Both in software simulation and in the experimental phase of the studies the JE is replaced by a de machine. The de machine is brought to an initial speed by the motoring operation of the IRI. Later, the IM is taken into generating mode and the de machine is into motoring mode of operation, This mode would correspond to the turbine catch-up initiation phase and initiate driving phase of the induction generator (IG) in the actual world, The generated power is then converted to a three-phase 3 empty set, 400 Hz tin software), 60 Hz tin hardware), 115 V voltage-regulated bus via a double stage power conversion utilizing a 20 kHz parallel resonant high frequency (HF) ac link and pulse density modulated (PDM) converter technology. Independent of the coupled machine speed, a constant amplitude and constant frequency 3 empty set voltage-regulated ac bus is formed and maintained by the proper control of the power converters.

Açıklama

Anahtar Kelimeler

Kaynak

Ieee Transactions on Aerospace and Electronic Systems

WoS Q Değeri

Q1

Scopus Q Değeri

Cilt

36

Sayı

4

Künye